Multiple 12V  Battery Auto Charger
Model : AMBC – 2 – 12V – 4B – 20A - B

       
        Features:

  • Suitable for parallel charging of up to 4 Nos. of 12V Batteries simultaneously and independently. Very useful for large Battery user.
  • Batteries of 80AH to 200AH can be charged at C/10 rate and 40AH to 100AH can be charged at C/5 rate.
  • Highly efficient SMPS based design with Constant Voltage charging facility, protects Batteries from overcharging.
  • Each Channel fully protected against over voltage, short circuit, over temperature and Battery reverse connection.
  • Each charging channel independently controlled for efficient charging of different AH batteries or batteries of unequal DOD.

 

4B_12V_20A_multi_battery_auto_charger

Specifications

1.

Input Voltage

:    230 VAC Single Phase  Input range 180 – 264 VAC

2.

Frequency

:    47-63 Hz

3.

Input

:    Through 3 core cable and 15 A, 3 pin plug provided on the side of  Battery Charger

4.

Battery Charger ON/OFF Switch

:    16 Amp rating Rocker Switch with Neon Indicating lamp Provided on the Front Panel.

5.

Display
Voltmeter
Current Meter

:    Display for each channel selectable by rotary switch.


    3 ½ Digit DPM for displaying Battery / Charger Voltage (in Volts). Accuracy 0.2V +/- 2 Digits

    3 ½ Digit DPM for displaying charging current (in Amp).  Accuracy 0.2A +/- 2 Digits

6.

No. of Channels/Charging Port

:    4. (Maximum Capacity 20A per Channel)

Specifications for each Channel/Charging Port

8.

Battery Charging Voltage

:   13.6 +/- 0.2V( Charge Complete Mode )
:   14.6 +/- 0.2V( Charging Mode )  

Change over from Charging Mode to Charging Complete Mode when the charging current reduces
 to < 1% AH.

9.

Charging Current

:   20 Amps max.

10.

Charging Current Adjustment

:   Maximum charging current can be Adjusted from 8A to 20A with adjustment on the front panel. 

11.

Battery Switch

:   Rocker switch 32A.

12.

Protections

:   Battery Charger protected against Over Load, Short Circuit and Battery reverse connection.

13.

Battery Connector

:  TB56 Series 2 Position, 1 each for +ve & -ve.

14.

Indications

:    Green LED for Charging Complete.
:    Yellow LED for Charging.
:    Red LED for Charger fail.
:    Red LED to indicate Reverse Battery Connection.

15.

Switches and Controls

:    Rocker Switch for Connecting Battery to Charger
:    Potentiometer for adjusting Current Limit.   

16.

Enclosure

:    IP 20.

14.

Mounting

:    Provision for Table top and wall / Panel mounting.

15.

Size

:    490(W) x 380(H) x 230(D) MM

16.

Weight

:    20 Kg.

 

 

Specifications subject to change without notice.